Talaria Mx5 Moto Brake Single Caliper Kit

Talaria MX5 Rear Moto brake Kit - Ultra Bee Stopping power on a Mx5

Looking for serious stopping power for Talaria MX5? Our Talaria MX5 Moto Brake Kit is the go to choice for Talaria riders who ride hard. Whether you chase balance point, rip trails, or want smooth predictable braking, this kit delivers!

What’s Included in the kit:

• Single Moto Caliper Bracket (Machined from Aerospace Grade Billet Aluminum, Anodized Black for color)

• Surron Ultra Bee Brake Assembly:

  • Moto Master Cylinder

  • Brake Line

  • Rear Brake Caliper

• 240mm x 3.3mm Stainless Steel Brake Rotor

Fits: ONLY TALARIA MX5

Why Choose the Emotoflux Talaria Moto Brake Kit?
Built for Talaria Riders Who Push Hard

Purpose built for the Surron Light Bee, this setup brings a true moto spec rear caliper and matching rotor for instant bite and consistent feel. No more spongy lever or brake fade when pushing your bike to its limit.

Serious Stopping Power and Precision Control

The oversized 240mm rotor adds surface area and sheds heat fast, so braking stays strong whether you are cruising, ripping trails, or throwing big tricks. Modulation is smooth and predictable, which makes balance point control and one handers easier and safer.

Built to last

Our Moto Brake components are all made from high quality materials

• 240MM Brake Rotor: Made From Stainless Steel & Coated for corrosion resistance

• Caliper Bracket: Made From Aerospace grade 6061 T6 aluminum

• Ultra Bee Brake Assembly: OEM Surron Quality, quick & easy install!

Installation notes

1. Remove your rear axle, wheel, & stock brake caliper bracket.
2. Remove the Ultra Bee caliper from the OEM bracket, then remove the rubber boot & caliper pin from OEM bracket and install onto our moto caliper bracket
3. Install the caliper onto the moto caliper bracket
4. Install the rotor onto your wheel
5. slide the Ultra Bee caliper & caliper bracket over the rotor & Re-install your wheel, tighten your rear axle to spec
6. run the brake line through your frame ( remove the banjo bolt on the caliper side if you need, then run the line down and re-install the caliper banjo. this makes re-bleeding easier )
7. Bolt the master cylinder to your handlebars, make sure everything is torqued to spec
8. Take your new ride for a rip! dont forget to bed in your pads slowly for atleast 1 hour before trying to stunt or get the brakes hot. THIS IS CRUCIAL for peak performance!

FAQs

• Does it fit the Surron Talaria MX5?
  Yes. This kit is made specifically for the Talaria MX5

• Can I add a foot brake later?
  Yes the system is compatible with our Moto Foot Brake Kit

• What rotor size is compatible?
  This kit is made to work with our 240MM Foot Brake Rotar. You can run a 220MM rotor for short periods if you MUST. But we do not recommend doing this, when you go to put a 240MM rotor later you MUST replace the pads so they can bed correctly!
  

Ships From USA!